PIAGGIO Beverly 300 i.e., Service Station Manual, Page: 41 / 333

Maintenance chart
M
AINTENANCE TABLE
I: INSPECT AND CLEAN, ADJUST, LUBRICATE OR REPLACE, IF NECESSARY C: CLEAN, R: REPLACE, A: ADJUST, L:
LUBRICATE
* Replace every 2 years
Km x 1,000 1 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80
Driven pulley roller casing L L L L L L L L
Safety fasteners I I I I I
Ignition spark plug R R R R R R R R
Centre stand bracket L L L L L L L L L L L L L L L L
Driving belt R R R R R R R R
Throttle control A A A A A A A A A
Air filter I I I I I I I I
Oil filter R R R R R R R R R
Valve clearance A A A A
Electrical system and battery I I I I I I I I I
Coolant level * I I I I I I I I I
Brake fluid * I I I I I I I I I
Engine oil R I R I R I R I R I R I R I R I R
Hub oil R I R I R I R I R
Brake pads I I I I I I I I I I I I I I I I I
Sliding shoes / CVT rollers R R R R R R R R
Tyre pressure and wear I I I I I I I I I
Vehicle road test I I I I I I I I I
Suspension I I I I I I I I I
Steering I I I I I I I I I
Time 60' 10' 10
0'
45' 15
0'
10' 14
0'
10' 15
0'
45' 10
0'
10' 19
0'
10' 10
0'
45' 15
0'
M
AINTENANCE
T
ABLE
- T
IME
Km x 1000 1 5 10 15 20 25 30 35 40 45 50 55 60
Operation Time 60' 10' 140' 10' 150' 10' 140' 10' 150' 10' 140' 10' 190'
Checking the spark advance
The ignition advance is determined electronically
on the basis of parameters known by the control
unit. For this reason it is not possible to interpret
the reference values based on the engine rpm.
The ignition advance value is detectable at any
time using the diagnostic tester. It is possible to
check whether the ignition advance determined by
the injection system matches the value actually
activated on the engine, by means of the strobo-
scopic light.
Proceed as follows:
- Remove the spark plug.
- Remove the plastic cover on the flywheel cover
shown in the picture.
Beverly Tourer 300 i.e.
Maintenance
MAIN - 41