PIAGGIO Beverly 300 i.e., Service Station Manual, Page: 251 / 333

DURING THE BLEEDING OPERATIONS, MAKE SURE THE BRAKE FLUID DOES NOT COME INTO
CONTACT WITH THE BODYWORK SO AS NOT TO DAMAGE IT. FURTHERMORE, DURING THE
BLEEDING OPERATIONS REGARDING THE BRAKE CALLIPERS, MAKE SURE THE BRAKE
FLUID DOES NOT COME INTO CONTACT WITH THE DISC BRAKES AND WITH THE BRAKE
PADS. FAILURE TO OBSERVE THIS PRECAUTION WILL ENDANGER THE PROPER WORKING
AND EFFICIENCY OF THE BRAKING SYSTEM
Specific tooling
020329Y Mity-Vac vacuum-operated pump
Locking torques (N*m)
System bleed calliper fitting: 12 ÷ 16 Nm
Brake fluid level check
The front and rear brake fluid reservoirs are both
positioned on the handlebar. Proceed as follows:
- Rest the vehicle onto the centre stand, with the
handlebar centred.
- Check the fluid level through the sight glass
« A ».
A certain lowering of the level is caused by wear
on the brake pads.
Front brake pump
Removal
- Remove the rear handlebar cover.
- Drain the braking system.
- Disconnect the brake fluid line from the pump,
paying attention to a possible escape of remaining
brake fluid.
- Remove the brake stop button from the lever.
- Undo the two U-bolt fixing screws.
- Remove the brake pump with the lever.
Refitting
- Upon refitting, perform the operation but in reverse order.
- Tighten the hydraulic line to the prescribed torque and purge the system.
- When the operation is over, tighten the brake fluid bleed screw to the prescribed torque.
N.B.
WHILE REFITTING, REPLACE THE COPPER GASKETS ON THEIR FITTINGS.
Beverly Tourer 300 i.e.
Braking system
BRAK SYS - 251