PIAGGIO Beverly 300 i.e., Service Station Manual, Page: 109 / 333

This section describes the operations to carry out when removing the engine from the vehicle.
Exhaust assy. Removal
- Remove the RH footrest.
- Remove the Lambda probe from its support and
disconnect it.
- Cut the fastening clamp on the lambda probe ca-
ble.
- Undo the two exhaust manifold fixings on the
head. To unscrew the nuts that fix the silencer
flange to the head properly, use a jointed wrench
that allows, according to the travel direction, to get
also at the right nut. That is difficult to do with a
traditional straight wrench.
- Undo the three screws that fix the silencer to the
supporting arm.
- Remove the full silencer unit.
Beverly Tourer 300 i.e.
Engine from vehicle
ENG VE - 109