-7-
PKI-0044
1 After installation, if the lamp does not activate
→ Check the wiring and make sure there are no faulty or irregular connections .
● If the switch illumination does not light up.
→ Verify the (+) wire from the switch is properly connected. If it is not correctly connected it will not activate.
→ Verify the fuse located on the vehicle’s wiring system. (the switch’s (+) wire should be connected to the
fuse box). If it is burned out, connect it to another circuit.
→ If the switch itself is faulty, the same symptoms may exist. We recommend that the entire switch unit
be replaced.
→ Check the fuse for the switch harness. If it is burned out, follow instructions indicated in
[ 3 Fuse replacement Procedures].
● The switch illumination lights up but when operating does not work.
→ Check the connecting (-) cord to the body earth.
→ There may be cases where each terminal related to specific sections may be incorrectly connected.
Check for any lose wires and also for dirt or grime.
→ Check the switch operation If an abnormality is found, replace it accordingly.
2 If the LED suddenly fails to light up …
→ Check the fuse located on the vehicle’s wiring system. If it is burned out, replace accordingly.
→ Check the fuse for the switch harness. If it is burned out, follow instructions indicated in
[ 3 Fuse replacement Procedures].
→ There may be cases where each terminal related to specific sections may be incorrectly connected.
Check for any lose wires and also for dirt or grime.
→ Check the switch operation if an abnormality is found, replace it accordingly.
3 Fuse replacement procedures
→ A short circuit may have occurred. Check the wiring system. If any type of damage is
found replace accordingly. (Non-replacement may pose a potential danger) (Short circuits are mainly
caused when wires are caught in the assembly or when there is a gap in the sleeve connected to the
lamp harness).
【3】Troubleshooting……Verify each section according to the following.
