5 Installation
20
Version: 1.0.0
MP124E
V-273 VC Linear Actuator
Suitable tools for fastening the screws
Affixing the movable part of the mounting to the V-273.430 model
1. Align the moving rod of the linear actuator in the mounting so that the
corresponding mounting holes in mounting and rod overlap.
2. Affix the movable part of the mounting to the holes in the rod of the V-273.
3. Check that the connected parts fit without backlash.
Attaching the V-273 to the fixed part of the mounting
1. Align the linear actuator or surface so that the corresponding mounting holes
in linear actuator and surface overlap.
2. Screw the screws into the mounting holes on the bottom side of the surface.
Maximum screw-in depth: 5 mm
Maximum torque: 2.6 Nm
3. Check that the V-273 fits on the surface without backlash.
5.4 Connecting the Motor Cable to the V-273
Prerequisites
You have read and understood the general notes on installation (p. 15).
The motor cable is
not
connected to the controller.
Tools and accessories
C-815.18 motor cable Sub-D 15 (m/f), 1 m, in the scope of delivery (p. 10)
Connecting the motor cable to the V-273
1. Connect the connector (f) of the motor cable to the Sub-D 15-pin panel plug
(m) of the linear actuator.
2. Secure the connector (f) with the two integrated screws against being
accidently pulled out of the linear actuator.