NOTICE
Excessively long screws and locating pins
Screws and locating pins that are inserted too deeply can damage the V-417.216211E1.
►
Pay attention to the
depth of the mounting and locating holes (p. 31)
►
Only use screws and locating pins of the correct length for the respective mounting holes.
Affixing the Load
1. If necessary: Insert the locating pins into the corresponding holes in the motion platform.
2. Align the load on the motion platform so that the mounting holes selected in the motion
platform can be used for mounting the load.
3. Place the load onto the motion platform so that the locating pins are inserted into the
corresponding locating holes in the load.
4. Tighten the screws in all mounting holes.
5. Check that the load is affixed firmly to the motion platform.
6.5
Connecting the V-417.216211E1
Tools and Accessories
■
Suitable cable set
■
If necessary: Suitable screwdriver for the locking screws of the connectors.
Requirements
✓
You have read and understood the
general safety instructions (p. 7)
✓
You have read and understood the user manual for the electronics used.
✓
You have installed the electronics properly.
✓
The electronics are switched off.
NOTICE
Damage due to incorrect connection of the V-417.216211E1!
Connecting unsuitable electronics or a wrong cable can damage the V-417.216211E1 or the
electronics.
►
Connect the V-417.216211E1 to
from PI miCos only.
►
Use cables from PI miCos only to connect the V-417.216211E1 to the electronics.
Connecting the V-417.216211E1
1. If necessary: Remove the ESD protective caps from the connectors of the V-417.216211E1.
2. All of the V-417.216211E1's connections must be made in the following order:
a) Purge air connector
b) Drive connector
c) Linear encoder connector
3. Secure the connectors against unintentional removal.
6 INSTALLATION
V417M0003EN
‒
11/19/2018
19
M O T I O N | P O S I T I O N I N G
