PI M-126, User Manual

Page: 21 / 53

5 Installation
M-126 Precision Microtranslation Stage MP42E Version: 3.0.0 17
5.1 General Notes on Installing
NOTICE
Unwanted changes in position when mounted vertically!
If the load exceeds the holding force of the M-126 when the drive is mounted vertically,
unwanted changes in the position of the platform will occur. Unintentional changes in the
position of the platform can damage the drive, the load or the surroundings.

If the M-126 is mounted vertically, make sure that the installed load is lower than the
holding force of the drive.
NOTICE
Protruding screw heads!
Protruding screw heads can damage the M-126.

Ensure that the screw heads do not protrude from countersunk holes so that they do not
interfere with the motion.
NOTICE
Cable break!
A cable break leads to failure of the M-126.

Install the M-126 so that the cable is not bent too strongly or crushed.
NOTICE
Damage to the drive screw by foreign bodies!
Foreign bodies and dirt penetrating the open drive screw of the M-126 could damage the drive
screw and interfere with platform's motion.

Install the M-126 so that foreign bodies and dirt cannot penetrate. If necessary, install
appropriate covers.

Remove any foreign bodies and heavy contamination immediately.
5 Installation