phytron
41
MA 1275-A004 EN
6.2 Parameterising the Module
When using encoders, the corresponding
phyLOGIC
TM
parameters
P34
to
P39
should be checked
and set.
For the power stage settings use the parameters
P43
to
P45
.
For a general overview of the parameters:
Further manual
Detailed information on this subject is in a supporting manual:
“
phyLOGIC
TM
Command Reference
for the
phyMOTION
TM
Controller”
Information about positioning you’ll find in:
Further manual
Detailed information on this subject is in a supporting manual:
“Principles of Positioning of the Stepper Motor Controllers“
Summary of Contents for phyMOTION INAM01.1
