Phytec phyCORE-MPC5200B tiny, Hardware Manual

Page: 42 / 104

phyCORE-MPC5200B tiny
34
©
PHYTEC Messtechnik GmbH 2006 L-678e_0
7.2 Ethernet Interface
Connection of the phyCORE-MPC5200B tiny to the world wide web
or a local network (LAN) is possible over the integrated FEC (Fast
Ethernet Controller) of the Freescale processor. The FEC operates
with a data transmission speed of 10 or 100 Mbit/s.
7.2.1 PHY Physical Layer Transceiver
The phyCORE-MPC5200B tiny has been designed for use in
10Base-T and 100Base-T networks. The 10/100Base-T interface with
its LED monitoring signals extends to phyCORE-connector X1. In
order to connect the module to an existing 10/100Base-T network
some external circuitry is required. The required 49,9 Ohm +/-1%
termination resistors on the analog signals (ETH_RX±, ETH_TX±)
are already populated on the module.
If you are using the applicable Development Board for the
phyCORE-MPC5200B tiny (part number PCM-997 + EAD-003-
MPC5200), the external circuitry mentioned above is already
integrated on the board (
refer to section 14 ).
The default PHY address configured with the boot-strapping option is
0x1.