Phytec phyCORE-LPC2292/94, Hardware Manual

Page: 120 / 144

phyCORE-LPC2292/94
108
©
PHYTEC Meßtechnik GmbH 2006 L-658e_5
16.3.11 Pin Assignment Summary of the phyCORE, the
Expansion Bus and the Patch Field
As described in section 16.1 , all signals from the
phyCORE-LPC2292/94 extend in a strict 1:1 assignment to the
Expansion Bus connector X2 on the Carrier Board. These signals, in
turn, are routed in a similar manner to the patch field on an optional
expansion board that mounts to the Carrier Board at X2.
Please note that, depending on the design and size of the expansion
board, only a portion of the entire patch field is utilized under certain
circumstances. When this is the case, certain signals described in the
following section will not be available on the expansion board.
However, the pin assignment scheme remains consistent.
A two dimensional numbering matrix similar to the one used for the
pin layout of the phyCORE-connector is provided to identify signals
on the Expansion Bus connector (X2 on the Carrier Board) as well as
the patch field.