Phytec phyCORE-i.MX31, Hardware Manual, Page: 108 / 135

phyCOREi.MX31
98
©
PHYTEC Messtechnik GmbH 2007 L-700e_0
13.5.16.2 Universal camera pin header (X8)
A 2 mm universal connector X8 can be used to adapt other camera types. It is possible to supply the
external side of the camera level shifter with a external supply (VCC_CAM_EXT on the connector). For
this, the jumper JP15 should be moved on the position 2-3. The pin-out of the connector is shown in the
table below:
Table 33: Universal camera pin header X8
P
IN
# S
IGNAL
N
AME
D
ESCRIPTION
1A VCC_CAM_EXT External power supply
1B VCC_CAM_EXT External power supply
2A VCC_3V3 Power supply
2B VCC_3V3 Power supply
3A x_RESET_3V3 /Reset
3B CAM1_SDA SDA Quick Capture
4A CAM1_SCL SCL Quick Capture
4B CAM1_GPIO I²C address config
5A CAM1_FV Frame start
5B GND Ground
6A CAM1_LV Line start
6B GND Ground
7A CAM1_DD9 Data 9
7B CAM1_DD8 Data 8
8A CAM1_DD7 Data 7
8B CAM1_DD6 Data 6
9A CAM1_DD5 Data 5
9B CAM1_DD4 Data 4
10A CAM1_DD3 Data 3
10B CAM1_DD2 Data 2
11A CAM1_DD1 Data 1
11B CAM1_DD0 Data 0
12A GND Ground
12B CAM1_PCLK Pixel clock input
13A GND Ground
13B CAM1_MCLK Clock output
14A GND Ground
14B x_SNAPSHOT Snapshot