Phytec phyCORE-167CR, Hardware Manual

Page: 104 / 114

phyCORE-167CR/167CS
94

PHYTEC Meßtechnik GmbH 2002 L-527e_8
The following figure shows the positions of the additional
components.
Figure 27: Positions of the Additional Components on the
debugCORE-167CR/167CS
The pin header row X3 provides a simple method of accessing the
supply voltage of the debugCORE-167CR/167CS and its reset signal
for the purpose of measurement.
The following table shows the pin layout.
Pin Signal
1 VCC
2 GND
3 /RESET
Table 56: Pinout Pin Header Row X3 on the debugCORE-167CR/167CS
Two LEDs D3 and D4 are provided for status display of the
debugCORE-167CR/167CS. LED D3 shows whether the controller is
in Adapt Mode or not, in other words, whether an emulation is in
progress. LED D4 shows whether the EINIT (end of initialization)
instruction was carried out.
Standard
phyCORE-167
D3 D4
X2
X2
S1
X3