PHYTEC
Page 10
1.
2.
U-Boot SPL 2020.04 (Nov 02 2020 - 19:09:42 +0000)
DDRINFO: start DRAM init
DDRINFO: DRAM rate 4000MTS
DDRINFO:ddrphy calibration done
DDRINFO: ddrmix config done
Normal Boot
Trying to boot from BOOTROM
image offset 0x8000, pagesize 0x200, ivt offset 0x0
NOTICE: BL31: v2.2(release):rel_imx_5.4.47_2.2.0-0-gc949a888e
NOTICE: BL31: Built : 18:54:44, Nov 2 2020
U-Boot 2020.04 (Nov 02 2020 - 19:09:42 +0000)
CPU: i.MX8MP[8] rev1.0 1800 MHz (running at 1200 MHz)
CPU: Commercial temperature grade (0C to 95C) at 47C
Reset cause: POR
Model: PHYTEC phyCORE-i.MX8MP
Watchdog enabled
DRAM: 2 GiB
MMC: FSL_SDHC: 1, FSL_SDHC: 2
Loading Environment from MMC... *** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
BuildInfo:
- ATF c949a88
- U-Boot 2020.04
Net:
Error: ethernet@30bf0000 address not set.
Error: ethernet@30bf0000 address not set.
No ethernet found.
Normal Boot
Hit any key to stop autoboot: 0
Booting from SD Card
Booting from the SD card is useful in several situations, e.g. if the board does not start anymore due to a damaged bootloader. To boot from SD card,
switch S1 position 1 has to be set to ON.
There are two ways to create a bootable SD card. You can either use:
A single, prebuilt SD card image
The four individual images (
-, kernel- and device tree image, and root filesystem)
u-boot
Single, Prebuilt SD Card Image
The first possibility is to use the SD card image built by
, a tool integrated in
. This image has the ending
and can be found under
Bitbake
Yocto
*.sdcard
buil
. It contains all BSP files in correctly preformatted
d/deploy/images/phyboard-pollux-imx8mp-1/phytec-qt5demo-image-phyboard-pollux-imx8mq-1.sdcard
partitions and can be copied to the SD card easily using the single
command
.
Linux
dd
Tip
The created file
is only a link to a file like
phytec-qt5demo-image-phyboard-pollux-imx8mp-1.sdcard
phytec-qt5demo-image-phyboard-pollux-
imx8mp-1-<BUILD-TIME>.rootfs.sdcard.
