Phytec kitCON-161CS, Hardware Manual

Page: 18 / 62

kitCON-161CS/JC/JI
12

PHYTEC Meßtechnik GmbH 1999 L-356e_2
An automatic software reset will execute the program following
download.
’’Hello World!..." appears on the screen of your Host-PC.
•
To leave the FlashTools press <F1>
To start the demo program again execute the following steps:
•
Disconnect the power source
•
turn switch 1 of Dip-Switch S3 OFF
•
Reconnect the power source
2.3 Internal Flash memory programming
- Ensure that DIP-switch3 S1 is ON and JP1 is closed between 1+2.
- Start the bootstrap loader by pressing reset switch S1.
- Start “Memtools” on your PC.
- Erase and program the internal flash with your application as
described in the Memtool help.
- Turn OFF DIP-switch3 S1 and change JP1 to 2+3.
- Reset the board by pressing switch S1. Your application starts from
the internal flash.
Note:
Erased Flash memory cells contain all ‘0’s, contrary to standard
EPROMs.
Note:
The new derivatives of the C161CS/JC/JI offer the “single chip
mode”. If you want to start the bootstrap loader in this mode, you
have to pull down the /RD pin after reset. This feature is NOT
implemented on the actual board design.