Photron Revision 1.03E, User Manual

Page: 77 / 93

4.4.3. Change Trigger Operation (RECORDING TYPE)
Normally for recording, the READY key is input and the high-speed camera is put in the READY
state, then the REC trigger is input and the recording operation is performed. However, by setting
the high-speed camera to direct trigger mode, the recording operation can be performed without
the READY key input.
In this way, you can reduce a step in the operation of the system.
①
Press the remote controller's MENU key to display the menu list.
②
Select RECORDING TYPE from the OTHERS submenu with the remote controller's ARROW keys.
③
Select either READY AND TRIG or DIRECT TRIG on the menu.
④
Press the ENTER key to confirm.

The operation of the high-speed camera for each item is shown below.
・
READY AND TRIG
READY key input is always necessary before the REC trigger.
(READY AND TRIG is the initial setting)
・
DIRECT TRIG
The recording operation can be performed with just the REC trigger, without the READY key input.
67
Remote Controller User’s Manual