01/2020
Figure 6: Scanner connectors, ethernet & power port pinout. Refer to sections
and
for more
details
4. Plug the Scanner into the power outlet.
a.
12 VDC power supply.
b. Use only the supplied power adapter (90-264 VAC / 12 VDC, 60 W).
c.
The I/O ports are reserved for future use.
5.
Download and install the PhoXi Control application from the Photoneo webpage.
6. Run the PhoXi Control application and try to make your first scan. Please refer to the
.
Status LEDs
As shown in Figure 5, status LEDs are located between the Ethernet port and the Power + GPIO port. The LEDs are
grouped into 3 groups of two and from top to bottom have the following statuses:
⬤
Power status
Power cable connected
⬤
Processing unit connected
On → Suitable power connected
Off → Under/overvoltage
⬤
Reserved
⬤
Reserved
⬤
Ethernet speed
Off → Indicates other than 100 Mbps
On → Indicates 100 Mbps
⬤
Ethernet activity
Off → Link is down
On → Link is up and inactive
Flashing Green → Link is up and active
PhoXi 3D Scanner - User Manual and Installation Instructions
12/36
