11
Warranty
The manufacturer alone reserves the right to recognize warranty claims.
11.1
Warranty Terms
The manufacturer warrants to distributor and end customer that for a period of two years
from the date of the shipment from manufacturer or distributor to end customer (the
"Warranty Period") that:
•
the product will substantially conform to the specifications set forth in the applicable
documentation published by the manufacturer and accompanying said product, and
•
the product shall be free from defects in materials and workmanship under normal use.
The distributor shall not make or pass on to any party any warranty or representation on
behalf of the manufacturer other than or inconsistent with the above limited warranty
set.
11.2
Warranty Claim
The above warranty does not apply to any product that has been modified or al-
tered by any party other than manufacturer, or for any defects caused by any use
of the product in a manner for which it was not designed, or by the negligence
of any party other than manufacturer.
11.3
Breach of Warranty
To ensure that your warranty remains in force, adhere to the following rules:
1.
Do not open the housing or destroy the warranty seal of the camera. Touching internal
electronic components of the camera may damage the camera electronic.
2.
Do not remove the camera serial number label. If the label is removed and the serial
number cannot be read out from the camera registers, the product identification and the
product traceability is no longer ensured.
3.
Avoid mechanical stress and damage of the camera connectors and the camera housing.
Secure the external connectors and cables against unusual force effects.
4.
Avoid power supply voltage levels above the camera specifications and reverse voltages.
5.
Avoid compensation currents over data cables. Use appropriate ground connections and
grounding materials in the installation of your vision system to ensure equal potential of
all chassis earth in your system.
6.
Avoid electromagnetic fields strengths and electrostatic charging levels which are over the
limits of the industrial standards cited in the conformity declaration of the camera.
7.
Prevent the camera especially water and moisture ingress. Prevent any liquid, flammable,
or metallic substances from entering the camera case.
MAN069 12/2018 V1.1
115 of 123
Summary of Contents for MV1-D4096 Series
