Photon Focus MV1-D2048-3D03 Series, User Manual, Page: 108 / 131

7 Software
7.8 Outliers Correction
The Outliers Correction feature is explained in Section 5.8. This section shows its properties.
7.8.1 Black Pixel Correction
The Black Pixel Outliers Correction can be enabled by the property
OutliersCorrection_EnBlackPixel (in category Correction / OutliersCorrection / BlackPixel ). A
black pixel must have a grey value smaller than OutliersCorrection_BlackLimit and the minimal
difference to its two neighbours on the same row is OutliersCorrection_BlackDiff . All values
are specified at 12 bit resolution, i.e. 4095 is the value for a saturated pixel.
7.8.2 White Pixel Correction
The White Pixel Outliers Correction can be enabled by the property
OutliersCorrection_EnWhitePixel
(in category
Correction
/
OutliersCorrection
/
WhitePixel
). A
White pixel must have a grey value bigger than OutliersCorrection_WhiteLimit and the minimal
difference to its two neighbours on the same row is OutliersCorrection_WhiteDiff . All values
are specified at 12 bit resolution, i.e. 4095 is the value for a saturated pixel.
7.9 Permanent Parameter Storage / Factory Reset
The property UserSetSave (in category UserSetControl ) stores the current camera settings in the
non-volatile flash memory. At power-up these values are loaded.
The property UserSetLoad (in category UserSetControl ) overwrites the current camera settings
with the settings that are stored in the flash memory.
The command CameraHeadFactoryReset (in category PhotonfocusMain ) restores the settings of the
camera head
The property
CameraHeadStoreDefaults
(in category
PhotonfocusMain
) stores only
the settings of the camera head in the flash memory. It is recommended to use
UserSetSave
instead, as all properties are stored.
The calibration values of the FPN calibration are not stored with UserSetSave (or
CameraHeadStoreDefaults ). Use the command Correction_SaveToFlash for this (see
Correction_SaveToFlash ).
7.10 Persistent IP address
It is possible to set a persistent IP address:
1. Set GevPersistentIPAddress (in category TransportLayerControl ) to the desired IP address.
2. Set GevPersistentSubnetMask (in category TransportLayerControl ) to the sub net mask.
3. Set
GevCurrentIPConfigurationPersistent
(in category
TransportLayerControl
) to True.
4. Set
GevCurrentIPConfigurationDHCP
(in category
TransportLayerControl
) to False.
5. The selected persistent IP address will be applied after a reboot of the camera.
.
108 of 131 MAN052 12/2018 V3.2