Photon Focus MV1-D1280-L01-1280-G2-12, User Manual, Page: 112 / 139

8 Software
1. Disable MROI by setting MROI_Enable to False. This is mandatory otherwise setting the
MROI entries will be ignored.
2. Set MROI_Index . In the first run it is set to 0 and then incremented in every run.
3. Set MROI_Y to the starting row of the MROI.
4. Set MROI_H to the height of the MROI.
5. Proceed with step 2, incrementing the
MROI_Index
. If no more MROI should be set, then
run the steps 2 to 4 again (incrementing
MROI_Index
) but set
MROI_H
to 0.
6. Enable MROI by setting
MROI_Enable
to True.
7. Read the property
MROI_Htot
. Set the property
Height
(in category
ImageFormatControl
) to
the value of MROI_Htot . This is mandatory as this value is not automatically updated.
Example pseudo-code to set two MROI: The resulting total height of the example will be 400.
SetFeature(’MROI_Enable’, false);
SetFeature(’MROI_Index’, 0);
SetFeature(’MROI_Y’, 50);
SetFeature(’MROI_H’, 100);
SetFeature(’MROI_Index’, 1);
SetFeature(’MROI_Y’, 600);
SetFeature(’MROI_H’, 300);
SetFeature(’MROI_Index’, 2);
SetFeature(’MROI_H’, 0);
SetFeature(’MROI_Enable’, true);
int heightTot;
GetFeature(’MROI_Htot’, &heightTot);
SetFeature(’Height’, heightTot);
8.8 Permanent Parameter Storage / Factory Reset
The property UserSetSave (in category UserSetControl ) stores the current camera settings in the
non-volatile flash memory. At power-up these values are loaded.
The property UserSetLoad (in category UserSetControl ) overwrites the current camera settings
with the settings that are stored in the flash memory.
The command CameraHeadFactoryReset (in category PhotonfocusMain ) restores the settings of the
camera head
The calibration values of the FPN calibration are not stored with UserSetSave . Use
the command Correction_SaveToFlash for this (see Correction_SaveToFlash ).
.
112 of 139 MAN077 11/2017 V1.0