Photon Focus MV0 CMOSIS Series, User Manual, Page: 105 / 111

C.1 Acquisition
5. The number of frame within a burst must be set by parameter AcquisitionBurstFrameCount
parameter.
6. Set the parameter EnAcquisitionFrameRate to False if the frames within a burst must be
acquired as fast as possible.
7. If the frames within a burst must be acquired with a certain speed, set the parameter
EnAcquisitionFrameRate
to
True
and configure either
AcquisitionFrameTime
or
AcquisitionFrameRate
accordingly.
8. The required image
Width
and
Height
must be set.
9. The required
PixelFormat
must be set.
10.
AcquisitionMode
must be set to
Continuous
.
11. The software command AcquisitionStart() must be applied.
It might be necessary to adjust the polarity of the Line0 input signal. This can be done by the
parameter LineInvert in the section DigitalIOControl.
C.1.5 Triggered controlled exposure mode
The exposure time can be controlled by an externally applied trigger signal on LineIn input.
The following configuration procedure shows how to set the camera in the triggered
controlled exposure mode:
1. Parameter
ExposureMode
must be set to
TriggerControlled
.
2. The TriggerMode of ExposureStart and ExposureEnd trigger must be set to On . The
AcquisitionStart , FrameStart and FrameBurstStart trigger must be set to Off .
3. The TriggerSource of the ExposureStart trigger must be set to Line0 .
4. The TriggerActivation of the ExposureStart trigger must be set to RisingEdge .
5. The TriggerSource of the ExposureEnd trigger must be set to Line0 .
6. The TriggerActivation of the ExposureEnd trigger must be set to FallingEdge .
7. TriggerDelay and TriggerDivider of the ExposureStart and ExposureEnd trigger must be set
accordingly.
8. The required image
Width
and
Height
must be set.
9. The required
PixelFormat
must be set.
10.
AcquisitionMode
must be set to
Continuous
.
11. The software command
AcquisitionStart()
must be applied.
MAN078 12/2018 V1.1 105 of 111