Phoenix RPC12 Series, Cli Reference Manual

Page: 149 / 245

150 Phoenix RPC12 Series CLI Reference Manual • September 2008
show debug-log
Description
Note – This command should only be used by service technicians, or with the
advice of a service technician.
Shows the debug logs for the RAID storage controller (SC), the management
controller (MC), the semaphore trace, task logs, or all of them. If no logs are
specified, all logs are shown.
Input
show debug-log mc [
entries
]
show debug-log sc controller a|b|both region boot|error|debug|all
show debug-log sem-trace-log [ entries ]
show debug-log task-log [ entries ]
show debug-log all
Parameter Description
mc
Specifies to show MC debug logs.
entries
Optional. Specifies the number of MC logs
to show, which is recommended because
debug logs can be very large.
sc
Specifies to show SC logs only.
controller a|b|both
Specifies whether to show SC debug logs
for controller A (upper), controller B
(lower), or both.
region boot|error|debug|all
Specifies the type of SC logs to show:
•
boot
: Shows only the boot log.
•
error
: Shows only error logs recorded
for previous SC crash or improper
shutdown.
•
debug
: Shows only debug logs.
•
all
: Shows all logs.
sem-trace-log
Specifies the semaphore trace log.