LEDLT
Installation Instructions
Phoenix Products Company Inc.
8711 West Port Avenue Milwaukee, WI 53224 USA
Phone: +1 414.973.3300 Toll Free: 800.438.1214 Fax: +1 414.973.3210
www.phoenixlighting.com
!
CAUTION
•
All wiring should be done by a licensed electrician in accordance with state codes, local codes, National Electric Code (NEC) standards and International
Electrotechnical Commision (IEC) standards.
•
Improper installation may result in serious injury and void warranty.
•
Keep plugs and receptacles dry. This fixture should only be used on Ground Fault Circuit Interrupter (GFCI) protected circuits.
•
Contains parts and assemblies susceptible to damage by electrostatic discharge (ESD).
•
When using luminaires, basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury. When used in wet
locations, circuit(s) or outlet(s) must have GFCI protection. Receptacles with built-in GFCI protection should be used for this measure of safety.
To Remove the LED Assembly
1.
Loosen outer gear (Item 1) and hexagon nut (Item 9) from each end of fixture. This will allow the entire end cap assembly to be removed from the
PC tube (Item 5).
2.
Remove end cap assembly from PC tube (Item 5).
3.
Remove LED assembly (Item 10) from PC tube (Item 5) by rotating the LED assembly 90˚ inside the PC tube (Item 5). The LED assembly (Item 10)
should then slide out.
To Reassemble the Fixture
1.
Insert LED assembly (Item 10) into PC tube (Item 5) and rotate 90˚so the LED assembly (Item 10) is between the notches in the PC tube (Item 5).
2.
Insert entire end cap assembly into PC tube (Item 5).
3.
Tighten outer gear (Item 1) and hexagon nut (Item 9) on each end of fixture.
10
11
4
4
1
2
3
5
6
2
1
9
End cap assembly
End cap assembly
8
7
