![background image](http://html1.mh-extra.com/html/phoenix/ks0030-series/ks0030-series_user-instruction_1551267001.webp)
CAUTION:
Do not keep the keys in the safe.
1. OPENING THE SAFE
To open the door of the safe for the first time: Press 1,5,9 (this is
the preset numbers when the safe leaves the factory) and
confirm by pressing the letter “A”. You will hear a beep and the
green light will be on, then open the door using the knob within
5 seconds.
If you or an intruder uses the incorrect group of numbers, it will
not open. If the incorrect combination is used 3 times
consecutively, you must wait for 20 seconds before
reattempting.
If again the incorrect combination is selected 3 times, you must
wait approximately 5 minutes before reattempting access.
2. PROGRAMMING THE CODE
A. Press the red button “X” (see diagram 1) on the back of the
door near the hinge, release it and you will hear two beeps.
B. Now press from 3 to 8 numbers that you wish to use as a
combination, and confirm by pressing the letter “B” within 15
seconds. Or you have to do from the beginning.
C. Write down your new combination immediately and check
whether your new combination has been programmed or not
on conditions of the safe door open.
3. BATTERY REPLACEMENT WARNING
If the batteries are low, the red light (in the left) will warn you
immediately. To test the batteries, just input your personal
numbers to open the door. If the batteries are low, the red light
will be on. If nothing happens, it means that the batteries are
in order.
4. REPLACING THE BATTERIES
The safe requires 4 X size “AA” (1.5V R06) batteries. Open the
safe, push the battery cover plate “Y” (see diagram 1) on the
back of the door and replace the 4 P CS old batteries. You must
reprogram the code, using the above third step. Use of alkaline
batteries is recommended.
5. OVERRIDE INSTRUCTION TO OPEN SAFE
For your convenience, we have engineered a manual override
system for your safe. If you forget or misplace your combination,
remove the small central plate “Z” (see diagram 2) on the front
panel, insert the key into the keyhole and turn it in a counter-
clockwise direction, then turn knob in a clockwise direction
towards the right. This will manually open your safe at any time.
6. INSTALLING THE SAFE
To reduce the risk of theft of the safe, it can be secured to floor,
wall or in a cupboard. For your convenience, there are two holes
(diameter 8mm) both in the bottom and on the back; therefore it
can be fixed by the expansion bolts supplied.
CAUTION:
The safe should be placed horizontally when installing the safe.
Diagram 1
Diagram 2
X
Y
Z
1
4
7
9
2
5
8
0
3
6
9
8
KS0030
SERIES
KEY SAFES
USER INSTRUCTION