2
YAK54 MK2
Instruction Manual
INSTALLING THE AILERONs SERVOS
1. Install the rubber grommets and brass eyelets onto
the aileron servo.
2. Using a modeling knife, remove the covering from over
the servo box.
3. Place the servo into the servo box. Center the servo
and drill pilot holes through the block of wood for
each of the four mounting screws provided with the
servo.
4. Using the thread as a guide and using masking
tape, tape the servo lead to the end of the
thread: carefully pull the thread out. When you
have pulled the servo lead out, remove the
masking tape and the servo lead from the
thread.
5. Repeat step # 2 - # 5 to install the second aileron
servo in the opposite wing half.
Make certain the hinges are adequately secured with glue. If
they come loose in flight accidents may result.
Secure nylon hinges with instant glue, being careful
not to glue the wing and airleron together.
Apply instant glue (CA glue, super glue).
Align the center line of main wing with aileron.
Cut away film only. here
Supplied with the servo
2mm
Must be purchased
separately!
Assemble left and right
sides the same way
Cut off shaded portion
Set all scerws securely. If they come off during
flight you will lose control of your aircraft!
Tie the string.
Pull out servo
cord with string.
Warning!
Aileron
Aileron
D
D
