Phoenix Model Tiger Moth, Instruction Manual

Page: 19 / 40

2 x 10mm Screw
3 x 20mm Cap Screw
2
Nut
2mm
2
Cut off shaded portion
INSTALLING THE ELEVATOR PUSHROD
1. Locate the pushrod exit slot on the right side
and left side of the fuselage. It is located
slightly ahead and below the horizontal
stabilizer.
2. Carefully cut away the covering material from
the slot.
3. Working from inside the fuselage, slide the
threaded end of the pushrod until it reaches the
exit slot. Carefully reach in with a small screw
driver and guide the pushrod out of the exit slot.
4. Install the nylon clevis into the two elevator
pushrod. Make sure 6mm of thread shows inside
the clevis.
5. The control horn should be mounted on the
bottom, left side and right side of the elevator.
6. Remove the covering from the slot on the
elevator. Insert and secure the control horn in
place.
7. Attach nylon clevis to the control horn and
secure it .
8. Locate one nylon servo arm, and using wire
cutters, remove all but one of the arms. Using a
2mm drill bit, enlarge the third hole out from the
center to accommodate the elevator pushrod wire.
9. Plug the elevator servo into the receiver and
center the servo. Install the servo arm onto the
servo. The servo arm should be perpendicular
to the servo and point toward the middle of the
fuselage.
10. With the elevator halves and elevator servo
centered, carefully place a mark on the elevator
pushrod wire where it crosses the hole in the
servo arm.
11. Using pliers, carefully make a 90 degree bend
up at the mark made. Cut off the excess wire,
leaving about 8mm beyond the bend.
12. Make the same way for the second elevator.
TIGER MOTH
Instruction Manual
18
3x20mm