14
P40 KITTY HAWK
Instruction Manual
45
CA glue
To carburator
To muffler
To vent Tube
46
SERVO INSTALLATION
INSTALLING THE FUSELAGE SERVOS
1. Install the rubber grommets and brass collets
into the elevator, rudder and throttle servos.
Test fit the servos into the servo tray. Trim the
tray if necessary to fit your servos
2. Mount the servos to the tray using the mounting
screws provided with your radio system.
49
Control horn
Control horn
50
48
Control horn elevator
INSTALLING THE ELEVATOR PUSHROD
1. Locate the pushrod exit slot on the right side
and left side of the fuselage. It is located
slightly ahead and below the horizontal
stabilizer.
2. Carefully cut away the covering material from
the slot.
3. Working from inside the fuselage, slide the
threaded end of the pushrod until it reaches the
exit slot. Carefully reach in with a small screw
driver and guide the pushrod out of the exit slot.
4. Install the clevis into the two elevator pushrod.
Make sure 6mm of thread shows inside the clevis.
5. The control horn should be mounted on the
bottom, left side and right side of the elevator at
the leading edge, in line with the elevator pushrod.
6. Drill two holes through the elevator using the
control horn as a guide and screw the control
horn in place.
7. Attach clevis to the hole in the control horn.
Install a silicone tube on the clevis.
47
Rudder servo
Elevator servo
Elevator Rod
