Phoenix Contact UM IA THERMOMARK X1.1, User Manual

Page: 102 / 130

THERMOMARK X1.1
4-2
PHOENIX CONTACT 103180_00_ia
4.1.3 General Cleaning
• Remove dust and paper fuzz in the printing area with a soft brush or vacuum cleaner.
• Clean outer surfaces with an all-purpose cleaner.
4.1.4 Clean
ing
the
P
ressure
R
oller
• Disconnect the THERMOMARK X1.1 from the mains.
• Make sure that the print mechanism has cooled down.
• Remove the cutter by loosening the screw and pulling the cutter toward you.
• Open the cover.
• Turn lever (item 1, Figure 4-2 on page 4-5) counter clockwise to lift the printhead.
• Remove labels and ink ribbon from the printer.
• Remove deposits with a soft cloth.
• If the roller appears damaged, replace it (see "Replacing the Pressure Roller" on
page 4-5).
Abrasive cleaning agents can damage the printer
Do not use abrasives or solvents to clean the outer surfaces or assemblies.