Phoenix Contact RAD-900-DAIO6, User Manual, Page: 75 / 140

Configuration and startup
3827_en_B PHOENIX CONTACT
73/138
5.5 Copying device settings via memory stick
To transfer the configuration of a wireless module to another wireless module, save the
configuration to a memory stick (RAD-MEMORY, Order No. 2902828).
Common network parameters
– Operating mode
– Network ID
– RF band
– Data rate of the wireless interface
– Encryption
– Network type
Individual device parameters
– Station name
– RAD ID
– Transmission power
– List of permitted connections
– Serial interface parameters
5.5.1 Saving parameters from the wireless module to the
memory stick
Copying common network parameters and individual device parameters to the memory
stick:
1. Press the SET button located on the wireless module and hold down for at least six
seconds.
2. The four RSSI bar graph LEDs start a light sequence from bottom to top.
3. Insert the memory stick in the S port of the wireless module. The copying of parameters
is started automatically.
4. Wait until the light sequence stops. The write process has been completed.
5. Remove the memory stick from the wireless module.
WARNING: Explosion hazard when used in potentially explosive areas
Do not insert or remove the memory stick in a potentially explosive atmosphere.
Pay attention to the firmware version of the wireless modules before using the memory
stick. In order to ensure that a wireless module is capable of reading the memory stick, it
must have the same or later firmware version as the wireless module whose configuration
file is to be copied. Wireless modules with a lower firmware version are not able to read
the memory stick.