Phoenix Contact IB IL 24 PSDO 8-PAC, User Manual, Page: 96 / 112

IB IL 24 PSDO 8-PAC
96 / 112
PHOENIX CONTACT 7619_en_05
B 3.2 Diagnostic messages for parameter errors for
SafetyBridge
Table B-3 iParameter parameter errors
Error Code
(Hex)
Error cause Remedy
03F2 iPar_CRC is incorrect Check iParameters, repeat calculation.
03FA iPar_CRC is not equal to F_iPar_CRC Apply correct value.
03FB PST_Device_ID is incorrect Correct value (20
hex
for IB IL 24 PSDO 8-PAC).
03FC F_Destination_Address in the iParameters is incorrect Correct value.
Make sure that the value set under F_Destina-
tion_Address and the value that you have set
via the 10-pos. DIP switch are the same.
03FD Incorrect order of iParameter blocks Check infrastructure components.
Table B-4 F-Parameter parameter errors
Error code Error cause Remedy
dec hex
1088 440 The parameterized SafetyBridge address does not
match the address set on the safety module.
Make sure that the addresses are the same.
1089
...
1094
441
...
446
Internal error Please contact Phoenix Contact.
71 47 The configurable safety module detected a distortion in
the configuration and parameter data record.
Attempt transmission again.
If the error occurs permanently, the data record
in the controller is distorted. In this case, you
can get SAFECONF to generate a new data re-
cord.