Phoenix Contact IB IL 24 PSDO 8-PAC, User Manual, Page: 12 / 112

IB IL 24 PSDO 8-PAC
12 / 112
PHOENIX CONTACT 7619_en_05
1.6 Directives and standards
The manufacturers and operators of machines and systems, in which the
IB IL 24 PSDO 8-PAC module is used, are responsible for adhering to all applicable direc-
tives and legislation.
For the standards observed by the module, please refer to the certificate issued by the ap-
proval body and the EC declaration of conformity. These documents are available on the
Internet at phoenixcontact.net/products .
1.7 Intended use
Only use the INTERBUS-Safety, SafetyBridge or PROFIsafe system in accordance with the
instructions in this section.
The IB IL 24 PSDO 8-PAC safety module is designed exclusively for use in an
INTERBUS-Safety, SafetyBridge or PROFIsafe system.
It can only perform its safety-related tasks within the system if it has been integrated into the
execution process correctly and in such a way as to avoid errors.
You must observe all information in this user manual as well as in the documents listed in
“Documentation” on page 13. In particular, only use the module according to the technical
data and ambient conditions specified in Section 10, "Technical data and ordering data" on
Page 82 and onwards.
Within an INTERBUS-Safety, SafetyBridge or PROFIsafe system, the safety module can be
used to achieve safety functions with the following requirements depending on the condi-
tions of use:
– Up to SIL 3 according to standard EN 61508
– Up to SILCL 3 according to standard EN 62061
– Up to Cat. 4/PL e according to standard EN ISO 13849-1
It is designed for connecting single-channel or two-channel actuators, which can be used in
association with safety technology.
For example, the module can be used in the following applications:
– Safety circuits according to EN 60204 Part 1
– Safe shutdown of contactors, motors (24 V DC), valves, ohmic, inductive, and capaci-
tive loads
The module is not suitable for applications in which stop category 1 also has to be observed
in the event of an error.
For additional information about stop categories, please refer to the INTERBUS-Safety
system description UM EN INTERBUS-SAFETY SYS.