FL WLAN EPA 2
4-32
PHOENIX CONTACT
108452_en_00
•
Issue the “AT&F” command and reboot.
4.3
PROFINET communication
WLAN communication with PROFINET devices requires that “Bridge Mode” is set to “Layer
2 tunnel” on the “WLAN Settings” page using web-based management.
For WLAN and Bluetooth communication with PROFINET devices, it is recommended to
enable the PROFINET optimizations. This can either be done using the EasyConfig mode
or manually using an AT command.
Other real-time protocols
Profinet optimizations are also sensible when using other protocols with real-time require-
ments. Due to the large number of protocols, a general recommendation cannot be given
here. To this end, it may be necessary to perform a test.
Bluetooth optimizations
The performance of a Bluetooth Access Point (NAP) can be improved by specifying the
number of clients (PANU).
ATS2010=n (n=1…7, number of devices)
Table 4-1
Default settings (default upon delivery)
Network Settings
IP Assignment
Static
IP Address
192.168.0.254
Subnet Mask
255.255.255.0
Default Gateway
192.168.0.
254
WLAN Settings
Operating Mode
Client
Channel
Bands
2.4 GHz and 5 GHz
Authentication Mode
Open
Channel
Auto
Client Operating Mode
Layer 2 tunnel
Bluetooth Settings
Operating Mode
PANU (Client)
Local Name
Generated from MAC address
Security Mode
Disabled
System Settings
Password
-
Setting a secure password for the device is strongly recommended.
