Phoenix Contact Axioline F, User Manual, Page: 68 / 86

AXL F PSDO8/3 1F
68
PHOENIX CONTACT 105739_en_04
Safe digital outputs
Quantity 4 two-channel or 8 single-channel (positive switching)
Supply From supply voltage U
O
Maximum output current per output (channel) 2 A
1.5 A (from 45°C according to CUL
US
)
Maximum output current for all outputs (total current) 8 A
6 A (from 45°C according to CUL
US
)
Maximum output current for each group (total current)
Group 1 (OUT0_K1, OUT1_K1, OUT2_K1, OUT3_K1) 4 A
3 A (from 45°C according to CUL
US
)
Group 2 (OUT0_K2, OUT1_K2, OUT2_K2, OUT3_K2) 4 A
3 A (from 45°C according to CUL
US
)
Maximum output voltage in the low state < 5 V
Maximum leakage current in the low state 2 mA
Minimum withstand voltage of the connected loads > 5 V
Maximum inductive load 1 H
Maximum capacitive load 10 µF per channel
10 µF in total
Minimum load 1.5 k

(16 mA at 24 V)
Limitation of the voltage induced on circuit interruption -15 V
Output voltage U
O
- 1 V, approximately
Simultaneity 100% up to 45°C (observe maximum current load)
Maximum switching frequency 1 Hz; 0.2 Hz at > 1 A
Filter time None
Switch-off delay for shutdown according to stop category 1 250 ms / 500 ms / 1 s / 2 s / 4 s / 8 s / 16 s / 32 s / 64 s / 128 s
Accuracy: ±5% of the set value
see Section 5.2 “Parameterization of the safe outputs” on page 34
Maximum duration of the test pulses (when switched off; active driving) 1 ms
WARNING: Loss of safety function
The use of unsuitable power supplies can result in the loss of the safety function.
• Only use power supplies according to EN 50178/VDE 0160 (PELV) for the voltage supply at the bus coupler.
• Make sure that the output voltage of the power supply for the bus coupler does not exceed 32 V even in the event of an error.
• Observe the general safety notes: see Section 1.2 “Electrical safety” on page 10.
WARNING: Loss of safety function
Switching the load at the maximum leakage current can result in the loss of the safety function.
• Please note that at this current, the load must not switch to or remain in the ON state.
• Please take this into consideration when selecting the actuator.
WARNING: Loss of safety function
Switching the load at the minimum withstand voltage can result in the loss of the safety function.
• Please note that at this voltage, the load must not be switched or remain in the ON state.
• Please take this into consideration when selecting the actuator.
WARNING: Loss of safety function
The switch-on pulse can result in the loss of the safety function.
• Please note that the load on a switch-on pulse (light test) of 1 ms must not fail or respond in a safety-critical way.
• Please take this into consideration when selecting the actuator.