Phoenix Contact Axioline F, User Manual, Page: 59 / 86

Errors: messages and removal
105739_en_04 PHOENIX CONTACT
59
8.2.3 Parameterization errors
Parameterization errors generate priority 1 diagnostic messages in the DiagState object.
These errors cannot be acknowledged. The parameterization must be checked and
corrected.
• In order to determine what type of parameterization error has occurred, use the
software to access the controller online and read the error.
Table 8-11 Parameterization errors (cannot be acknowledged)
AXIO code
+ AddValue
Error cause LED Description/effect Remedy
0x2382
+ 0x02F2
At least one output with
parameterized switch-off
delay is still performing a
switch-off operation
FS
flashing
The module is kept in the safe
state.
Wait until the switch-off operation is
complete and resend parameter
data to the module.
0x6320
+ 0x023X
The parameterization of
two related outputs does
not correspond to the
two-channel setting
Correct value and resend parameter
data to the module.
0x6320
+ 0x02EX
The parameterized
switch-off delay time for
the output is outside the
permissible value range
Correct value and resend parameter
data to the module.
0x6320
+ 0x029X
For outputs
parameterized for two-
channel operation, the
same settings were not
assigned for the switch-
off delay
Correct value and resend parameter
data to the module.
0x6320
+ 0x03F2
Calculated and received
parameter data
checksums do not match
Check checksums and resend
parameter data to the module.
0x6320
+ 0x03FB
Device type ID is
incorrect or wrong
module is being used
Check whether the correct module is
being used.
If you are unable to remove the error,
please contact Phoenix Contact.