Phoenix Contact Axioline F, User Manual, Page: 58 / 86

AXL F PSDO8/3 1F
58
PHOENIX CONTACT 105739_en_04
8.2.2 Supply voltage errors
Table 8-10 Supply voltage errors
0x2380 Hardware fault or cross-
circuit error
SD
on
All
OUT:
red
on
The indicated output cannot be
disabled. As a result all outputs are
kept in the safe state.
Read channel number via
DiagStateChannelNo object 0x033.
This diagnostic message can be
acknowledged. Acknowledgment
deletes the message and enables
the outputs.
0x5010 Hardware fault SD
on
All
OUT:
red
on
A hardware fault at the reference
voltage source of the outputs has
been detected by internal selftest
mechanisms. As a result all outputs
are kept in the safe state.
This diagnostic message can be
acknowledged. Acknowledgment
deletes the diagnostic message.
Restart is only possible following an
error-free power up selftest.
If the power up selftest is not error-
free, the module must be replaced.
AXIO code Error cause LED Description/effect Acknowledgment/remedy
AXIO code Error cause LED Description/effect Acknowledgment/remedy
0x3411 Undervoltage at
supply U
O
UO
flashing
SD on
An undervoltage has been detected
at supply U
O
. If U
O
< 17 V, a
diagnostic message is generated.
All module outputs are kept in the
safe state.
The U
O
LED is permanently on again
as soon as no undervoltage can be
detected.
Check supply voltage and correct.
Check supply line length and load.
This diagnostic message can be
acknowledged. Acknowledgment
deletes the message and enables
the outputs.