Phoenix Contact Axioline F, User Manual, Page: 29 / 86

Assembly, removal, and electrical installation
105739_en_04 PHOENIX CONTACT
29
4.1.4 Mounting and removing the module
Mounting the bus base
module
Snapping on and
removing the electronics
module
• Place all bus base modules required for the
station on the DIN rail (A).
• Push the bus base modules into the
connection for the bus coupler or the
previous bus base module (B).
A
B
Snap on
• Place the electronics module vertically on
the corresponding bus base module on the
DIN rail until it snaps into place with a click.
Make sure that the device connector for the
bus base connection is situated above the
corresponding socket on the bus base
module.
Remove
• Before removing the module, remove all
connectors.
• Insert a suitable tool (e.g., bladed
screwdriver) into the upper and lower snap-
on mechanisms (base latches) of the
module one after the other to release it (A).
• Remove the module perpendicular to the
DIN rail (B).
A
A
B