Phoenix Contact 2700689, User Manual, Page: 19 / 52

Startup and functions
8289_en_04 PHOENIX CONTACT
19 / 52
4 Startup and functions
4.1 Basic settings
4.1.1 Delivery state/factory settings
Upon delivery or after the system is reset to the default settings, the following functions and
properties are available by default:
– The user name is “admin”
The password is “private”.
– All IP parameters are deleted. The switch has no valid IP parameters:
IP address: 0.0.0.0
Subnet mask: 0.0.0.0
Gateway: 0.0.0.0
– PROFINET DCP is activated as the addressing mechanism.
– All available RJ45 ports are activated with the following parameters:
- Auto negotiation
- Autocrossing
– All counters of the SNMP agent are deleted.
– Web server and SNMP agent are active.
– MRP is disabled.
– In the case of the IP20 switch, the alarm contact only opens in the event of non-redun-
dant power supply.
– The aging time is set to 40 seconds.
– The switch is in “PROFINET” operating mode.
The basic Ethernet functions do not have to be configured and are available when the
supply voltage is switched on.