Configuration via PSI-CONF
104275_en_c00
PHOENIX CONTACT
3-1
3
Configuration via PSI-CONF
The device is supplied with the following configuration:
–
Line operation
–
DSL:
Automatic data rate detection in the range from 192 kbps to 5.696 Mbps per channel
DSL port A: active
DSL port B: active
–
Serial interface:
RS-232 activated, 19.2 kbps, no flow control, 8N1 (8 data bits, no parity, 1 stop bit)
RS-485 deactivated
RS-422 deactivated
–
Digital switching outputs:
3.1
Installing PSI-CONF
The PSI-CONF software is used to configure the PSI-MODEMSHDSL/SERIAL. The confi-
guration software supports:
–
Configuration of serial interfaces (selection of active interface, data rate, handshake,
etc.)
–
Changes to the configuration of digital switching outputs
–
Changes to the DSL transmission speed
–
4-wire operation:
64 kbps ... 30 Mbps (manual setting of the data rate)
384 kbps .... 11.392 Mbps (automatic detection of the data rate)
–
2-wire operation:
32 kbps ... 15.3 Mbps (manual setting of the data rate)
192 kbps ... 5.696 Mbps (automatic detection of the data rate)
–
Assignment of device names
–
Assignment of line names
–
Printing project/device files
–
Diagnostic function
–
Reading the log book
–
Update firmware
–
Reset to default settings
DSL A
DO = "24 V"
Good to very good connection
DO = "open"
No or only moderately good connection
DSL B
DIO = "24 V"
Good to very good connection
DIO = "open"
No or only moderately good connection
If you wish to configure the modem differently or would like to use the diagnostic function,
you must install the PSI-CONF configuration software.