Phoenix Contact 2313643, User Manual, Page: 38 / 94

PSI-MODEM-SHDSL/ETH
38
PHOENIX CONTACT 104273_en_01
4.2 Connections and LEDs
Connection terminal blocks (COMBICON)
1 24V Supply 24 V
2 0V Supply 0 V
3 DO Switching output, digital (24 V, open)
4 DIO Switching output, digital (24 V, open)
5/6 A (a)/(b) DSL port A (wire pair 1)
7/8 B (a)/(b) DSL port B (wire pair 2)
Interfaces
18 USB Mini-USB, type B, 5-pos., interface for configuration and diagnostics
19 RJ45 Ethernet interface (TP port)
Status and diagnostic indicators
9 VCC (green) Supply voltage
On Supply voltage OK
Flashing (1 Hz) Supply via USB (only for configuration)
Flashing (2 Hz) Error during boot process (ERR also flashes)
10 DIAG (yellow) Diagnostics
Off No serious errors
Flashing (1 Hz) (Duration: 20 seconds after booting)
Device is in default settings
Flashing (2 Hz) Remote access from another device (data transmission
during remote configuration, remote diagnostics, firm-
ware update)
On Serious error occurred -
read out of diagnostic data is recommended
11 ACT (yellow) Ethernet interface
On Data traffic on Ethernet interface
12 LINK (green) Ethernet interface
Off No connection
On Connection established
13 ERR (red) Error
Flashing (2 Hz) Error during boot process (VCC also flashes)
On Telegram error/installation error
14 LINK (green) DSL ports
16 Off DSL port not active
Off (pulsating) (Flashing every 3 s) DSL port is searching for link device
Flashing (1 Hz) Link partner found
Flashing (2 Hz) Initializing connection
Flashing (4 Hz) ERR ON / STAT DSL OFF = Installation error: e.g., line
structure configured, but 4-wire point-to-point connec-
tion implemented
On Connection established
15 STAT (yellow) DSL ports
17 Off No connection established
Off (pulsating) (Lights up every 3 s) Connection quality adequate
On (pulsating) (Goes out every 3 s) Connection quality good
On Link quality very good
PSI-MODEM-SHDSL/ETH
Ord.-No. 23 13 643
VCC
DIAG
ACT
LINK
ERR LINK
STAT
LINK
STAT
14
1
5
16
17
18
1 0
11
12
13
7
8
9
DSL
A
DSL
B
ETH
ETH
USB
1 2 3 4 5 6
19