GB5
WelcomeEye Connect / Touch / 09/17
5. PRODUCT INSTALLATION
Important notes and advice:
-
To make the most of your intercom panel, we recommend configuring it (RFID, for 1 or 2
families, 1 or 2 intercoms, loudspeaker volume) before final installation. To do this, a table
connection may be necessary to check that the settings are correct.
- If you test your product before installing it, ensure that you do not test it with the intercom
panel and the monitor in the same room to avoid the video doorphone emitting a shrill
noise (feedback).
- Do not expose the camera lens to direct sunlight or a reflective surface.
- We recommend running the cables through a protective sheath to protect them against
breakage and bad weather.
- For the WelcomeEye Connect version, to make the most of your monitor’s Wi-Fi function,
we advise you to check that your Wi-Fi network is accessible from where it is installed.
1. Wiring
To avoid the risk of interference and malfunctions, do not run the videophone cable through
the same sheath as the electrical cables.
Warning
:
Do not double up the wires to increase their section.
a. Connecting the videophone (monitor, intercom panel and camera)
Wires to be used: two wires 0.75mm
2
with 80m length or two wires 1.5mm
2
with 120m length.
- Make sure to connect the wires in accordance with one of the wiring diagrams depending
on the desired configuration.
- Refer to the label stuck to the back of the monitor and the back of the intercom panel.
- Configure the switches on the back of the intercom panel as well as the monitor interface
according to the chosen configuration (see section 2 intercom configuration).
b. Connecting a gate motor
- The intercom provides a dry contact (without power) to be connected to the push button
control of the automatic opener.
- Connect it directly to terminals 5 and 6 at the back of the intercom panel (no need to
observe polarity).
- The opening function is only possible if the video of the respective intercom panel is
displayed.
c. Connecting a strike plate or electric lock
Important
:
The strike plate or electric lock that you are ordering must have a mechanical
memory. The strike plate current cannot exceed 1.1A.
- Connect it directly to terminals 7 and 8 at the back of the intercom panel (no need to
observe polarity).
- The opening function is only possible if the video of the respective intercom panel is
displayed.
Summary of Contents for WelcomeEye Connect DES9900VDP - 531002
Page 238: ...WelcomeEye Connect Touch 09 17 ...
Page 239: ...WelcomeEye Connect Touch 09 17 ...
