Philips Vari-lite VL3015LT, Service Manual, Page: 31 / 184

T
ROUBLESHOOTING
: E
RROR
M
ESSAGES
0 2 . 9 6 9 8 . 0 0 1 0 0 13
2
Troubleshooting
Error Messages
If a problem occurs during luminaire calibration, at the end of the calibration sequence the Menu
Display will cycle through any applicable error message(s) until the end of the list is reached. To
review the error messages again, it will be necessary to access them using the
Status
function.
To access error messages:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until
Fixture
appears. Press [Enter].
Step 3. Press [Up]/ [Down] arrows to access
Status
. Press [Enter]. (Display will now scroll
through any error messages or display OK if no errors.)
WARNING: As with any repairs or maintenance to VARI
❋
LITE luminaires, service should only be
performed by a trained and qualified service technician or at an Authorized VARI
❋
LITE Service
facility.
Table 2-1: Error Messages
Display Message
OK No Errors Found
Pan/Encoder/Fail Pan encoder failure.
Tilt/No Sens Tilt sensor not found.
Tilt/Encoder/Fail Tilt encoder failure.
Index1/No Sens Gobo 1 Index sensor not found.
RotGobo1/No Sens Rotating Gobo wheel 1 sensor not found.
Index2/No Sens Gobo 2 Index sensor not found.
RotGobo2/No Sens Rotating Gobo wheel 2 sensor not found.
Index3/No Sens Gobo 3 Index sensor not found.
RotGobo3/No Sens Rotating Gobo wheel 3 sensor not found.
Dimmer/No Sens Dimmer sensor not found.
Cyan/No Sens Cyan sensor not found.
Yellow/No Sens Yellow sensor not found.
Magenta/No Sens Magenta sensor not found.
ColWheel1/No Sens Color wheel 1 sensor not found.
ColWheel2/No Sens Color wheel 2 sensor not found.
CTO/No Sens CTO sensor not found.
Frost/No Sens Frost sensor not found.
Prism/No Sens Prism sensor not found.