BDL3230QL
7
2.3.2. ID Remote Control
You can set the remote control ID when you want to use this remote
control on one of several different displays.
Press [
ID
] button. The red LED blinks twice.
1. Press [ID SET] button for more than 1 second to enter the ID
Mode. The red LED lights up.
Press the [ID SET] button again will exit the ID Mode. The red LED
lights off.
Press the digit numbers [
0
] ~ [
9
] to select the display you want to
control.
For example: press [
0
] and [
1
] for display No.1, press [
1
] and [
1
] for
display No.11.
The numbers available are from [
01
] ~ [
255
].
2. Not pressing any button within 10 seconds will exit the ID Mode.
3. If an error pressing of buttons other than the digits occured, wait
1 second after the red LED lights off and then lights up again, then
press the correct digits again.
4. Press [
ENTER
] button to confirm. The red LED blinks twice and
then lights off.
NOTE:
• Press [
NORMAL
] button. The green LED blinks twice, indicating the
display is in normal operation.
• It is necessary to set up the ID number for each display before
selecting its ID number.
