REGISTER THIS PRODUCT WITH PHILIPS SELECON: www.seleconlight.com/warrantyreg
Version 4: October 2010
ARENA range
FRESNELS
(8-inch/10-inch lens)
and PC
(8-inch lens)
OPERATION MANUAL
THANK YOU FOR PURCHASING A PHILIPS SELECON FIXTURE.
WE HAVE DESIGNED THIS FIXTURE TO PROVIDE YOU WITH A SUPERIOR
FITTING IN PERFORMANCE, DESIGN & ENGINEERING. WE ARE
CONFIDENT THAT IT WILL PERFORM TO YOUR EXPECTATIONS FOR
MANY YEARS TO COME.
Before operating your new fixture please read this information to assist you in making maximum use of your
fixture, its maintenance and care. If you would like further assistance contact your Philips Selecon dealer or
Philips Selecon.
LAMPING YOUR FIXTURE
The Arena Fresnels and PC range are fitted with a G38 lamp socket for the 120V CYX 2000W lamp.
Before relamping
– DISCONNECT THE FIXTURE FROM THE POWER SUPPLY. Be aware also that
the lamp or fixture may still be hot, so exercise necessary caution to avoid burns. Please note also
that these fixtures are not suitable for mounting on a normally flammable surface.
Release the clip fastener and swing down the rear door.
Insert lamp taking care not to touch the quartz envelope with your fingers.
Close door and lock off the fastener.
RIGGING YOUR FIXTURE
Your fixture uses a theatre lamp with a grid filament. To avoid premature lamp
failure it is essential that the fixture is always mounted so the yoke is horizontal
and with the lamp base down, i.e: the lamp adjustment knob is at the bottom of
the rear lamp plate.
To mount on theatre standard scaffold pipe
(48mm O.D) use theatre
hookclamps. The fixture is supplied with a 12mm set screw, washers and nut.
Please note we recommend the use of Megaclamp or similar heavy duty
clamp for use with the Arena range.
To mount on a telescopic stand
(Order Code: STDTH), reverse the yoke under the fixture and bolt the
stand’s spigot onto the 12mm set screw.
IMPORTANT NOTE
:
Before discarding the packaging ensure you have the suspension bolt set,
color frame /or the lamp.
