Service Modes, Error Codes, and Fault Finding
5.
5.2
Service Mode
5.2.1
Factory Mode
There are two ways to enter the factory mode:
1.
On the set:
•
Push the
y
button and turn on the AC power.
2.
With the remote control:
•
Turn on the set and provide a signal source on an input
(this to prevent to enter the power save mode). On the
remote control press “-”, “-”, “+”, “+”, “-”, “+”, “-”, “+”,
“SET”, “MENU”.
•
Please note that this set does not respond on the
standard Philips remote controllers, but only responds
to the with the set supplied remote control.
•
When in the factory mode at the top right of the menu
an “F” is displayed.
•
To exit the factory mode turn off the set.
Figure 5-1 Remote control.
I_17540_007.ep
s
2
8
010
8
