Features
• Universal Supply
• Regulated KNX TP1 and Aux Supply, Output, Short Circuit protected
• DIN Rail mount enclosure for easy installation
Important Notes
Read Instructions
– We recommend that you read this Instruction
Manual prior to commencement of installation.
Output
– The load on this device should not exceed the specified
rating. This device should be fed via a HRC fuse or MCB.
Mounting Location
– Install in a dry, well-ventilated location indoor only.
KNX Data Cable
– Use approved KNX TPI data cable.
Installation
– Device must be installed by KNX certified personnel
and cabled in accordance to the standards detailed on the official KNX
Associations website.
Electrical Diagram
WARNING
•
•
•
• Risk of electric shock
• Do not cut or terminate live wires. De-energize and
isolate all supply, load and control wiring prior to
installation or servicing. Do not expose this device
to rain or moisture. The device is only suitable for
indoor installation and must be earthed. Check all
wiring terminations prior to energizing the device.
Installation, programming and maintenance must be
carried out by qualified personnel only.
• Do not connect KNX TP1 bus to mains or load
wiring.
• KNX TP1 bus is SELV (Safety Extra Low Voltage)
and it must be isolated and segregated from mains
and other wiring as per the local wiring rules and
KNX installation recommendations.
• Do not open the device.
PPS640-KNX
Network Power Supply
INSTALLATION MANUAL
ISOLATE FROM MAINS SUPPLY PRIOR
TO INSTALLATION OR SERVICING. NO USER
SERVICEABLE PARTS INSIDE. INSTALLATION
AND SERVICE BY QUALIFIED PERSONNEL
ONLY
+
–
Supply:
100-240V
50/60Hz
1 Phase
Reset
On
Overload
N
L
+
–
KNX OUT
28-31VDC
AUX OUT
30VDC
(PE)
