14
EN
6 Listen to radio
Store radio stations
automatically
Note
•
You can program a maximum of 20 FM and 10 AM
radio stations.
•
When entering FM or AM mode for the first
time, the product prompts you to search and
store all the available radio stations.
1
Press
SOURCE
repeatedly to select FM or
AM tuner mode.
»
[AUTO INSTALL-PRESS PLAY-STOP
CANCEL]
is displayed.
2
Press
to start full scan.
»
[AUTO]
is displayed.
»
The product stores all the available
radio stations automatically, and then
broadcasts the first available station.
»
The station list is memorized in the
product. When you enter the radio
mode next time, the station scan does
not take place.
Note
•
If you press , the product will not perform full scan,
and the same message will pop up when you enters FM
or AM mode next time.
• You can also press and hold
PROG
for two seconds to activate automatic
programming.
»
[AUTO]
is displayed.
»
The product stores radio stations with
sufficient signal strength automatically.
»
The first stored radio station is
broadcast automatically.
Tune to a radio station
Tip
•
Keep the product away from other electronic devices
to avoid radio interference.
•
For better reception, fully extend and adjust the
position of the antenna.
1
Press
SOURCE
repeatedly to select FM or
AM tuner.
2
Press and hold / for two seconds.
»
[SEARCH]
is displayed.
»
The radio tunes to a station with
strong signal automatically .
3
Repeat step 2 to tune to more stations.
• To tune to a station with weak signal,
press /
repeatedly until you find
better reception.
Store radio stations manually
Note
•
You can program a maximum of 20 FM and 10 AM
radio stations.
1
Tune to a radio station.
2
Press
PROG
to activate the program
mode.
»
A position number is displayed.
3
Press / to allocate a number to this
radio station, then press
PROG
to confirm.
4
Repeat steps 1 to 3 to program other
stations.
Tip
•
To overwrite a programmed station, store another
station in its place.
Summary of Contents for NTX401
Page 2: ......
