Mechanical Instructions
4.
4.2
Service Positions
For easy servicing of this set, there are a few possibilities
created:
•
The buffers from the packaging (see figure “Rear cover”).
•
Foam bars (created for Service).
4.2.1
Foam Bars
Figure 4-5 Foam bars
The foam bars (order code 3122 785 90580 for two pieces) can
be used for all types and sizes of Flat TVs. See figure “Foam
bars” for details. Sets with a display of 42" and larger, require
four
foam bars [1]. Ensure that the foam bars are always
supporting the cabinet and
never
only the display.
Caution:
Failure to follow these guidelines can seriously
damage the display!
By laying the TV face down on the (ESD protective) foam bars,
a stable situation is created to perform measurements and
alignments. By placing a mirror under the TV, you can monitor
the screen.
4.3
Assy/Panel Removal ME
8
Styling
4.3.1
Rear Cover
Warning:
Disconnect the mains power cord before you remove
the rear cover.
Note:
it is
not
necessary to remove the stand while removing
the rear cover.
Refer to next figures for details.
1.
Remove the screws [1] and [2].
2.
Lift the back cover from the TV. Make sure that wires and
flat coils are not damaged while lifting the rear cover from
the set.
Figure 4-6 Back Cover Removal
E_065
3
2_01
8
.ep
s
171106
1
Re
qu
ired for
s
et
s
42"
1
I_17750_007.ep
s
25020
8
2
1 1
2
2
2
2
2
2
2
2
2
1
1
2
