37
H
in
ts & T
ip
s
Problems when faxing or printing
Faxes are of poor quality.
Change the resolution setting to
F
or
f
.
Check the document or set a higher contrast with
function 47 (see chapter
Fax & Copy
/ Con-
trast).
Test the fax machine by making a copy. If your
copy is faultless the correspondent’s fax machine
might be defective.
Call service if necessary.
Your fax or your recipient’s fax machine produces
black lines when printing.
Clean the scanner with a cloth (see Care).
Test the fax machine by making a copy. If your
copy is faultless the correspondent’s fax machine
might be defective.
Call service if necessary.
Copy is blank.
Load the document with the printed side up.
Call service if necessary.
Problems with the connection
Your fax machine rings once, then there is a mo-
ment of silence and another ring signal after that.
This is entirely normal. After the fi rst ring signal
the fax machine takes over the call. When the fax
machine has recognised that the incoming call is
a telephone correspondence, the fax machine will
continue to ring.
NO
CONNECTION
or
REDIAL
FAILED
Try later or draw your fax partner’s attention to a
possible installation fault.
NO
LOOP
CURRENT
Check the installation of your fax machine.
When you lift the cordless handset you do not
hear the dial tone.
Connect your telephone cable to the socket on
your fax machine identifi ed with
LINE
.
BUSY
or
fax transmissions are constantly interrupted.
Try to send the fax manually: Press
z
and dial
the fax number. If the recipient is using an auto-
matic answering device, wait until you hear a tone
after the pre-recorded message. Press
START
.
You cannot receive any faxes.
Set the number of ringing signals for the answer-
ing machine or the total number of ringing signals
with function 31 or 32 to lower than fi ve.
On lifting the cordless handset you hear a tone or
silence.
You are receiving a fax. At the fax machine: Press
START
. At an additional telephone: press
*
and
5
. Replace the handset.
EXTERNAL
PHONE
The red lamp
v
fl ashes.
This is not a fault.
You are now using an addi-
tional telephone.
Problems with the cordless handset
There is no dial tone on the cordless handset.
Place the cordless handset on the base station and
wait at least 12 hours until the batteries are fully
recharged.
You cannot hear a dial tone even though the cord-
less handset has been recharging on the base sta-
tion for more than 12 hours.
Get closer to the fax machine so you are within
the maximum range.
Please contact your dealer for new batteries of the
type AAA.
Summary of Contents for magic 3 voice dect
Page 1: ...PHILIPS ...
Page 45: ...45 Appendix ...
Page 46: ...46 Appendix ...
Page 47: ...47 Appendix ...
