Installation Instructions
ID_95_Centris_Wall
Standalone or continuous run configurations
Wall
Centris
ATTENTION: Install in accordance with national and local building and electrical codes.
!
Page 1
ID-95_Centris_Wall.pdf 0316
© 2016 Philips Lighting Holding B.V. All rights reserved
Phone: 604.888.6811
Web: philips.com/luminaires
!
Attention:
INSTALL IN ACCORDANCE TO NATIONAL
AND LOCAL ELECTRICAL CODES AND
BUILDING CODES.
WALL MOUNT JOINT 950-wall
IMPORTANT: Leave protective
film on fixture and endcaps during
installation. Remove after installation
is complete.
POWER LOCATIONS ONLY:
1.
Install backing for mount bracket at power locations.
If desired, allow for utility box mounted sideways
behind fixture mount.
2A
. JUNCTION BOX BEHIND MOUNT BRACKET
(see detail A) Install
a switch box sideways flush with finished wall.
Connect power cord (supplied) to the power line.
Secure the power cord with strain relief supplied on
the junction box side. Attach supplied cover (see
3A) with two #6-32x3/8” screws (supplied), feeding
cord through the hole provided in the cover. Attach
mount onto cover with three #10-32x1/4” screw
(supplied). Adjust mount bracket to the required
height. Allow at least 12 inches of cord outside the
wall for connection. Secure the switch box cover to
the wall structure through the two side slots using
two #8 or 10#
wood screws (supplied by others).
2B
. JUNCTION BOX ABOVE FIXTURE (see detail B)
Run power cord (supplied) from junction box
through switch box cover to the fixture. Crimp the
strain reliefs (supplied) on the cord inside junction
box. Allow at least 12 inches of cord outside the wall
for connection.
