Philips L04A AB, Service Manual, Page: 14 / 90

Mechanical Instructions EN 14 L04A AB 4.
4.3.2 Side AV Assy/Panel Removal
Figure 4-4 AV assy/panel removal
Remove the IO bracket by pulling the fixation clamp [1] while
sliding it away from the front side.
4.3.3 Trident assy/panel Removal
Figure 4-5 AV assy/panel removal
Figure 4-6 Trident assy
1. Remove screw [1] at the bottom of the Trident bracket.
2. To remove bracket pull both fixation clamps [2] while lifting
at the opposite side near the heatsink [3].
3. To remove shielding bracket push fixation clamps [4] and
pull at the top.
4. To remove the Trident assy from the remaining bracket
release the two fixation clamps [5] (see Trident assy)
4.4 Set Re-assembly
To re-assemble the whole set, do all processes in reverse
order.
Note: before you mount the rear cover, perform the following
checks:
1.
Check whether the AC power cord is mounted correctly in
its guiding brackets.
2. Check whether all cables are replaced in their original
position
E_14770_041.eps
010904
E_14770_042.eps
010904
3
2
4
1
E_14770_043.eps
010904
3
www.freeservicemanuals.info