Philips IntelliVue Series, Installation And Service Manual

Page: 426 / 522

Troubleshooting
7-140
Maintenance, Troubleshooting, and Repair
Step 22. Close the
Printer Icon
window by clicking on the
X
in the upper right corner of
the window to return to the
Printers
window of
Figure 7-64
.
Step 23. Repeat this procedure for each
Printer Icon
to be added.
When all desired
Printer Icons
have been added to
Figure 7-64
, Printers can be configured
to specific Information Centers, Clients, and the Server in the Network Configuration
window in the Config Wizard. See “Adding Network Devices” on page 6-28.
Adding Printers
to the Network
The
Network Configuration
window in
!Config Wizard
is the only way printers can be
added to the system. It operates in both monitoring and non-monitoring mode and only on
the Database Server.
A maximum of 8 LaserJet Printers can be connected to a network and 8
Printer Names
and
IP Addresses
have been preloaded into the system for assignment to individual printers.
Printer Names
are:
lj_00 1
lj_00 2
lj_00 3
lj_00 4
lj_00 5
lj_00 6
lj_00 7
lj_00 8
IP Addresses
are:
172.31.254. 1
172.31.254. 2
172.31.254. 3
172.31.254. 4
172.31.254. 5
172.31.254. 6
172.31.254. 7
172.31.254. 8
Restoring RAID
Configurations
If the RAID Configuration is lost or accidentally deleted, it can be restored using the
following steps. After RAID configurations have been restored, Windows Operating System
and Philips software must be reinstalled.
ML370 G3 Server
The following procedure describes how to set the RAID configuration.
During the Boot Up process, watch for the message (about 30 seconds)
Press <F8> key to
run the Option ROM Configuration for Arrays Utility . When it appears:
Step 1. Press the keyboard F8 key to display the Main Menu window.
Step 2. Select
Create Logical Drive
using the arrow key and press
Enter
to display its
menu.